arrow_back
Module 1: Introduction to MEP Testing and Commissioning
1-Testing-Commissioning-and-Maintenance-Procedures-for-MEP-Services
Overview of MEP Systems (Mechanical, Electrical, Plumbing, Fire & ELV)
Objectives and Importance of Testing & Commissioning (T&C)
Roles and Responsibilities of Project Team during T&C
Module 2: Pre-Commissioning Preparation and Documentation
2-Pre-Commissioning-Preparation-and-Documentation
Review of Drawings, Method Statements, and Checklists
Equipment Installation Verification and Pre-Startup Inspections
Documentation Requirements – Test Formats, Certificates, and Reports
Module 3: HVAC System Testing and Commissioning
3-HVAC-System-Testing-and-Commissioning
Air Balancing, Water Balancing, and System Performance Verification
Chiller, AHU, FCU, and Ducting System Testing Procedures
Functional Performance Testing and System Handover Documentation
Module 4: Electrical System Testing and Commissioning
4-Electrical-System-Testing-and-Commissioning
Electrical Continuity, Insulation Resistance, and Earth Resistance Tests
Testing of Switchboards, Transformers, Cables, and Panels
Load Testing, Functional Checks, and Energization Procedures
Module 5: Plumbing and Water Supply System Testing
Module-5-Plumbing-and-Water-Supply-System-Testing
Hydrostatic Pressure Testing for Water Supply Lines
Pump Testing, Flow Rate Measurement, and Leak Detection
Sanitary, Drainage, and Sewage System Testing & Certification
Module 6: Fire Fighting and Fire Alarm System Commissioning
6-Fire-Fighting-and-Fire-Alarm-System-Commissioning
Pump Room Testing – Jockey, Main, and Diesel Pumps
Sprinkler, Hydrant, and Hose Reel Testing Procedures
Fire Alarm System – Detector, Sounder, and Control Panel Verification
Module 7: ELV (Extra Low Voltage) and Building Automation Systems
7-Testing-Commissioning-and-Maintenance-Procedures-for-ELV-and-Building-Automation-Systems
Testing and Commissioning of CCTV, Access Control, and PA Systems
Structured Cabling, Data Network, and MATV Testing
Integration Testing of BMS and Central Monitoring Systems
Module 8: Maintenance Planning and Preventive Maintenance Procedures
8-Maintenance-Planning-and-Preventive-Maintenance-Procedures
Maintenance Schedules and Equipment Service Intervals
Preventive, Predictive, and Corrective Maintenance Strategies
Maintenance Logs, Records, and Spare Parts Management
Module 9: Troubleshooting and Performance Optimization
9-Troubleshooting-and-Performance-Optimization
Common Faults and Root Cause Analysis in MEP Systems
Energy Efficiency and Performance Fine-Tuning
Case Studies on Fault Diagnosis and System Improvement
Module 10: Final Acceptance, Handover, and Post-Commissioning Support
10-Final-Acceptance-Handover-and-Post-Commissioning-Support
Final Testing and Performance Verification Reports
Client Demonstration, Training, and Handover Documentation
Post-Commissioning Monitoring and Warranty Phase Support